Forum Post: RE: hdl reference design for ARV9001 for Artix-7 200T hardware Hi Andrei, Thankyou for your response, why is it necessary to use the entire design, is it not possible to use the tx_phy , tx_link, rx_phy and rx_link modules just? If i need to use the entire design and add microblaze instead of zynq, is it ok to replace the tx dma's and rx dma's because instead of microblaze doing the read and write of data i need to do it from own RTL which is 16 bit I and Q data coming from a outside chip to FPGA which i need to transmit via ADRV9001. And moreover is there a link where i can find the SDK design for using microblaze instead of zynq for this design. Best Regards, Tushar
https://ez.analog.com/fpga/f/q....-a/580821/hdl-refere